Plumbing and HVAC Service In Clarksville, IN

Executed comprehensive ductwork cleaning for 3,000 sq ft commercial space. Utilized Hypervac portable vacuum system with HEPA filtration. Cleaned supply and return ducts with rotating brush system. Sanitized ductwork with EPA-registered disinfectant fog. Cleaned and inspected all registers and grilles. Performed robotic camera inspection to verify thorough cleaning. Improved airflow efficiency by 30%.

Addressed indoor air quality concerns in 2,500 sq ft home. Installed Aprilaire 5000 whole-house air purifier on return side of HVAC system. Upgraded to MERV 13 filter. Sealed ductwork leaks using Aeroseal process, achieving 92% reduction in leakage. Installed Aprilaire 800 steam humidifier to maintain optimal humidity levels. Performed duct cleaning using Rotobrush aiR+ system with HEPA filtration. Collected before and after air samples for lab analysis. Results showed 85% reduction in airborne particulates and significant decrease in allergens post-treatment.

I performed a water purification system installation for a homeowner concerned about hard water and contaminants. I installed a reverse osmosis (RO) system under the kitchen sink, connecting it to the cold water supply line. After installing the system, I flushed the filters and tested the water for any remaining contaminants. The RO system is now filtering out impurities, providing the homeowner with clean, safe drinking water. I also reviewed maintenance steps with the homeowner to ensure the system stays efficient over time.

I was called out for an HVAC repair on a system that wasn’t cooling properly. After inspecting the unit, I found a refrigerant leak and a malfunctioning capacitor. I repaired the leak and recharged the system with R-32 refrigerant to restore cooling performance. I then replaced the faulty capacitor and tested the compressor and blower motor for proper operation. The system is now cooling efficiently, with a temperature drop of 22 degrees across the evaporator coil. After verifying the repair, I confirmed that the system is operating smoothly, providing the homeowner with reliable cooling.

I completed an IAQ (Indoor Air Quality) test for a homeowner concerned about airborne contaminants. Using a VOC sensor and particle counter, I measured levels of dust, pollen, and volatile organic compounds in the home. After reviewing the results, I recommended installing a UV-C air purifier to reduce pollutants. The air quality has been assessed, and the homeowner now has a plan for cleaner air.

Troubleshot an HVAC system that wasn’t heating properly. Discovered a faulty ignition control module preventing the furnace from igniting. Replaced the module with a compatible OEM part and tested the furnace. Ensured the ignition sequence was functioning correctly and the home was receiving adequate heat. The system is now back to normal operation.

Repaired a kitchen faucet that was leaking from the handle. Disassembled the faucet and found that the cartridge was worn out. Replaced the cartridge with a new OEM part and reassembled the faucet. Tested it to ensure the leak was fixed and the faucet was operating smoothly. The plumbing repair was completed quickly and effectively.

Conducted leak detection in a home with high water bills. Used a thermal imaging camera to locate a hot water leak in the slab foundation. After pinpointing the source, excavated the area and repaired the leak using sharkbite fittings. Tested the repair by monitoring the water meter for any further signs of leakage. The issue was successfully resolved.

Recently repaired a Goodman GSX16 AC unit that was not cooling properly. Diagnosed a refrigerant leak and a malfunctioning capacitor. Replaced the capacitor with a Goodman OEM part and sealed the refrigerant leak before recharging the system with R-410A. Ensuring proper component function and refrigerant levels is crucial for optimal performance. For expert AC repair services, trust Onsite to keep your HVAC system running efficiently and your home comfortable. Contact us for all your HVAC needs.

Conducted thorough maintenance on a York YXT24B21S air conditioning unit. Cleaned evaporator and condenser coils using Nu-Calgon Evap Foam No Rinse and Nu-Brite cleaners, respectively, to optimize heat transfer. Replaced clogged air filter with Filtrete MPR 1500 20x25x1 electrostatically charged filter. Checked refrigerant charge using Fieldpiece SMAN360 digital manifold, adjusting R-410A levels to manufacturer specifications. Tightened electrical connections and applied Noalox anti-oxidant compound to prevent corrosion. Lubricated condenser fan motor bearings with SAE 20 non-detergent oil. System now operating at peak efficiency, ensuring optimal cooling performance and energy savings.

In Clarksville, I inspected an HVAC system finding a dirty blower motor, slightly soiled evaporator coil, faulty capacitors, and a leaking Schrader core despite acceptable airflow and refrigerant levels. I secured exposed thermostat wiring and provided the homeowner an estimate for cleaning components and replacing defective parts.

Today, I repaired a Trane XR15 heat pump in a residential home that was struggling with heating efficiency. The issue was traced to a faulty reversing valve, which affects the heat pump's ability to switch between heating and cooling. I replaced the reversing valve and recharged the system with R-410A refrigerant. Additionally, I calibrated the thermostat to ensure accurate temperature control. These repairs restored the heat pump's functionality, ensuring it operates effectively across both heating and cooling modes.

Today, I performed routine maintenance on a Carrier Comfort Series air conditioner. The process included cleaning the condenser coils, checking the refrigerant levels, and replacing the air filter with a high-efficiency particulate air (HEPA) filter. I also inspected and tightened electrical connections to ensure reliable operation. This maintenance ensures the unit runs efficiently throughout the cooling season.

Installed an Air Scrubber Plus unit for a homeowner in Clarksville, IN. Positioned the unit within the HVAC system for maximum efficiency. Connected it to the existing ductwork and power source. Tested the unit to ensure proper functionality. Demonstrated to the homeowner how to operate and maintain the Air Scrubber for improved indoor air quality.

Successfully cleared a clogged toilet for a homeowner in Clarksville, IN. Utilized a plumber's auger to dislodge the blockage and restore normal flushing. Ensured efficient drainage and prevented potential backups. Residents can now use their toilet without worry in Clarksville, IN.

Performed an indoor air quality assessment and installed an air purifier for a homeowner in Clarksville, IN. Identified pollutants and allergens, ensuring cleaner air. The purifier filters out contaminants, enhancing indoor air quality and promoting a healthier living environment. Residents now breathe easier with improved air in Clarksville, IN.

Completed a thorough water heater flush to eliminate sediment buildup, enhancing the appliance's efficiency. Drained the tank, removed sediment deposits, and refilled it, ensuring the water heater operates at its best. Our client can now enjoy improved energy efficiency and extended appliance lifespan.

Conducted a comprehensive furnace tune-up for a homeowner. Inspected and cleaned key components, replaced air filters, and ensured peak performance. This preventative maintenance will keep the furnace running efficiently, minimizing the risk of unexpected breakdowns.

Performed drain cleaning service for a drain clog. Used hydro-jetting to remove stubborn blockages and restore water flow.

Responded to a gas furnace with intermittent heating. Diagnosed a faulty ignition system, replaced the igniter and recalibrated settings for consistent and reliable warmth.

Completed a furnace replacement from an older unit to a high-efficiency model. Safely removed the old system, installed the new furnace, and performed rigorous testing to ensure peak performance and energy savings.

Installed a high-efficiency tankless water heater. Ensured proper sizing, secure connections, and optimal placement for energy-efficiency and continuous hot water supply.

Identified a faulty thermostat causing inconsistent heating. Installed replacement thermostat and recalibrated the system for optimal performance. Checked that there is now even heating across the home.

Annual furnace maintenance service for a homeowner. Check furnace gas line, replace dirty filter with new air filter, clean the burners and test the smoke detector and carbon monoxide detector. All components are working well at this time and there is no need for repairs or parts replacements.

Emergency plumbing service for a clogged drain in the bathroom that was backing up water and overflowing. Cleared the drain and tested that there are no other blockages keeping water from flowing. Recommended preventative drain clearing to reduce buildup and prevent future clogs.